Superior DRL3042TEN Installation And Operation Instructions Manual page 54

Innovative Hearth Products
Superior™ DRL3000 Linear Direct-Vent Gas Fireplaces
•
Detailed lighting instructions are found on Page 63. Also, electronic fireplace lighting instructions are attached to
the CPI/IPI switch bracket.
The fireplace main burner can be turned ON/OFF with the wall switch or remote control. Check the batteries, at least
every three (3) months to ensure they are properly charged (Figure 2).
To light the fireplace in a power outage:
1. Confirm that batteries are installed in the battery pack.
2. Set the unit-mounted switch, or wall switch to the ON Position.
3. The unit should spark at the pilot and light.
4. Operate the fireplace normally.
NOTE: Install new batteries (4 AA) in the battery holder before the burn season (Page 37). Then, the fireplace can
automatically switch to battery power in the event of a power outage.
Fire hazard. Can cause severe injury or death. The wall switch receiver causes ignition of the appliance. The
appliance can turn on suddenly. Keep away from the appliance burner when operating the remote system or
activating manual bypass of the remote control system.
Property damage hazard. Excessive heat can cause property damage. The appliance can stay lit for many
hours. Turn OFF the appliance if it is not going to be attended for any length of time. Always place the
remote control transmitter where children cannot reach it.
Wall Switch Receiver Low Battery Power Detection
Battery life depends on several factors, including battery quality and number of fireplace ignitions. When the
batteries are low or depleted, the fireplace can only be operated manually (ON/OFF). When the receiver batteries are
low, it will emit three (3) beeps to alert of low batteries whenever the receiver ON/OFF button is pressed. When the
depleted batteries are replaced, the receiver will resume normal operation.
Remote Control Transmitter Low Battery Power Detection
When the transmitter batteries are low, the LED light will dim to alert of low batteries before losing all power. When
the depleted batteries are replaced, the transmitter will resume normal operation. Battery life depends on several
factors, including battery quality and number of fireplace ignitions. When the batteries are low or depleted, the
fireplace can only be operated manually (ON/OFF).
1. Replace the three (3) AAA batteries in the handheld remote control.
Remotely Turning ON the Appliance
1. Slide the wall switch to the REMOTE position (Figure 45).
2. Press the remote control ON/OFF key (Figure 46).
3. Two (2) beeps from the receiver will confirm receipt of the command, and the burner will light.
Remotely Turning OFF the Appliance
1. Press the remote control ON/OFF key (Figure 46).
2. The wall switch receiver will beep two (2) times, and the burner will turn OFF.
Key Lock
The key lock function disables the remote control keys to prevent unintended operation.
1. To activate or deactivate the key lock function, slide the safety lock switch to the desired position(Figure 46).
54
REMOTE (remote control)
NOTE: If there is no spark, replace the batteries.
WARNING
WARNING
Operation
900079-02 05/2015