Superior DRL3042TEN Installation And Operation Instructions Manual page 49

Innovative Hearth Products
Superior™ DRL3000 Linear Direct-Vent Gas Fireplaces
Installing Gas Conversion Kits
The gas supply shall be shut OFF prior to disconnecting the electrical power, before
proceeding with the conversion.
Avant d'effecteur la conversion, coupez d'abord l'alimentation en gaz, ensuite, coupez
l'alimentation electrique.
1. TURN OFF THE GAS SUPPLY TO THE FIREPLACE and disconnect power supply at the circuit breaker. Ensure
fireplace is cold.
2. If installed, remove the surround (Figure 44). Remove barrier.
3. Remove the glass door (Page 57).
4. Remove the glass media (Page 60).
5. Remove the front and rear floor sections (Page 55).
6. Remove the two (2) screws securing the burner assembly. Remove the burner assembly with the attached
venturi tube (Figure 48).
7. Remove the control compartment access door and gasket (Figure 48).
Figure 45: Removing the Burner and Accessing the Control Compartment
Right Burner
Bracket
Control Compartment
Access Panel and Gasket
8. Refer to the instructions provided with the regulator conversion kit. Using a Torx T20 driver (with 1/4" shank)
or slotted screwdriver, remove and discard the two (2) pressure regulator mounting screws, pressure regulator
tower, the diaphragm assembly (if applicable) and the spring. Ensure the rubber gasket installed on the back of
the replacement pressure regulator is properly positioned. Discard all removed components.
9. Install the new pressure regulator assembly using the supplied screws. Tighten the screws to 25 in. lbs.
10. Install the enclosed identification label to the valve body where it can be easily seen.
AVERTISSEMENT
Remove two screws
to remove burner
assembly.
Burner
Assembly
Venturi
Burner
Orifice
Right Burner Bracket
WARNING
Figure 46: Removing the Air Shutter
Installation
900079-02 05/2015
Adjustment Rod
Air Shutter
Adjustment
Rod
49