Connections - Denon AVR-1905 Operating Instructions Manual

5

CONNECTIONS

• Do not plug in the AC cord until all connections
have been completed.
• Be sure to connect the left and right channels
properly (left with left, right with right).
• Insert the plugs securely. Incomplete connections
will result in the generation of noise.
• Use the AC OUTLET for audio equipment only.
Do not use them for hair driers, etc.
Connecting the audio components
• When making connections, also refer to the operating instructions of the other components.
Connect the CD player's analog output
jacks (ANALOG OUTPUT) to this unit's
CD jacks using pin plug cords.
R
R
OUTPUT
Connecting a tape deck
Connections for recording:
Connect the tape deck's recording input jacks (LINE IN or REC) to this
unit's tape recording (CDR/TAPE OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or PB) to this
unit's tape playback (CDR/TAPE IN) jacks using pin plug cords.
NOTE:
If humming noise is generated by a tape deck, etc., move the tape
deck away.
• Note that binding pin plug cords together with AC
cords or placing them near a power transformer
will result in generating hum or other noise.
• Noise or humming may be generated if a
connected audio equipment is used independently
without turning the power of this unit on. If this
happens, turn on the power of the this unit.
CD player
OUTPUT
R L
DIGITAL AUDIO DIGITAL AUDIO
R L
Route the connection cords, etc., in
Connecting a CD player
such a way that they do not obstruct
the ventilation holes.
R L
R
L
R
L
CD recorder or
Tape deck
L R L
B
L R L
INPUT
Connecting the DIGITAL jacks
Use these for connections to audio (video) equipment with digital
output.
Refer to page 15 for instructions on setting this terminal.
NOTES:
• Use 75 Ω/ohms cable pin cords for coaxial connections.
• Use optical cables for optical connections, removing the cap
before connecting.
• The main unit's power must be turned on when recording via the
AVR-1905.
Connecting the PRE OUT jacks
Use these jacks if you wish to connect external power amplifier(s)
to increase the power of the front, center and surround sound
channels, or for connection to powered loudspeakers.
To use Surround back with one speaker, connect the speaker
to SURR. BACK L CH.
CD player or other component equipped
DIGITAL AUDIO DIGITAL AUDIO
OPTICAL COAXIAL
with digital output jacks
OUTPUT
B MD recorder, CD recorder or other component
INPUT OUTPUT equipped with digital input/output jack
OPTICAL
AC 230V, 50Hz
Power supply cord
Connecting the AC OUTLET
AC OUTLET
• SWITCHED (total capacity – 100 W)
The power to these outlets is turned on and off in conjunction with
the POWER operation switch on the main unit, and when the power
is switched between on and standby from the remote control unit.
No power is supplied from these outlets when this unit's power is at
standby. Never connect equipment whose total capacity is above 100
W.
NOTE:
Only use the AC OUTLET for audio equipment. Never use them for
hair driers, TVs or other electrical appliances.
ENGLISH
5