Surround - Denon AVR-1905 Operating Instructions Manual

Multi-source recording
Playing one source while recording another (REC OUT mode)
1
Press the REC SELECT button.
REC SELECT
(Main unit)
2
With "RECOUT SOURCE"
FUNCTION
displayed, turn the FUNCTION
knob to select the source you
wish to record.
(Main unit)
3
Set the recording mode.
• For operating instructions, refer to the manual
of the component on which you want to record.
4
To cancel, turn the function knob
FUNCTION
and select "SOURCE".
(Main unit)
NOTES:
• Recording sources other than digital inputs
selected in the REC OUT mode are also output to
the multi source audio output jacks.
• Digital signals are not output to the REC
SOURCE or audio output jacks.
• The DIGITAL IN's signal selected with the
function selector knob are output to the DIGITAL
OUT (OPTICAL) jack.
2, 4 1 2
2
Display
REC CD TUNER AUX DVD / VDP TV / DBS
VCR V.AUX CDR / TAPE
RECOUT SOURCE
11

SURROUND

Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the
different speakers. This adjustment can be performed with the system setup (see page 11) or from the remote
control unit, as described below.
• Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only
effective in the STANDARD (DOLBY/DTS SURROUND) modes. The adjusted levels for the different modes are
automatically stored in the memory.
1
Set the STANDARD (DOLBY/DTS SURROUND)
modes.
STANDARD
(Main unit) (Remote control unit)
2
Press the TEST TONE
button.
(Remote control unit)
3
Test tones are output from
the different speakers. Use
the channel volume adjust
buttons to adjust so that
the volume of the test
(Remote control unit)
tones is the same for all
the speakers.
NOTE:
• Please make sure the "AUDIO" position of
the slide switch on the remote control unit.
4
After completing the
adjustment, press the
TEST TONE button again.
(Remote control unit)
ENGLISH
1
1
3
3
2, 4
23