Denon AVR-1905 Operating Instructions Manual page 22

ENGLISH
After starting playback
[1] Adjusting the sound quality (tone)
• The tone control function will not work in the direct mode.
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
TONE
CONTROL
BASS
(Main unit)
2
With the name of the volume to
be adjusted selected, turn the
SELECT knob to adjust the level.
• To increase the bass or treble: Turn the control
clockwise. (The bass or treble sound can be
increased to up to +12 dB in steps of 2 dB.)
• To decrease the bass or treble: Turn the
control counterclockwise. (The bass or treble
sound can be decreased to up to –12 dB in
steps of 2 dB.)
[2] Listening over headphones
1
Plug the headphones' plug
into the jack.
Connect the headphones to
the PHONES jack.
The pre-out output (including
the speaker output) is
automatically turned off when headphones
are connected.
[3] Turning the sound off temporarily (MUTING)
1
Use this to turn off the audio
output temporarily.
Press the MUTING button.
Cancelling MUTING mode.
• Press the MUTING button again.
• Muting will also be cancelled when MASTER
VOL is adjusted up or down.
22
TREBLE
SELECT
(Main unit)
3
If you do not want the bass and treble to be
adjusted, turn on the tone defeat mode.
The signals do not pass through
TONE
DEFEAT
the bass and treble adjustment
circuits, so it provides higher
quality sound.
(Main unit)
NOTE:
To prevent hearing loss, do not raise the volume level
PHONES
excessively when using headphones.
1
(Remote
control unit)
[4] Combining the currently playing sound with the desired image
1
Simulcast playback
Use this switch to monitor a video
source other than the audio source.
Press the VIDEO SELECT button
repeatedly until the desired source
appears on the display.
Cancelling simulcast playback.
• Select "SOURCE" using the VIDEO SELECT
button.
2 3 1
• Switch the program source to the component
connected to the video input jacks.
[5] Checking the currently playing program source, etc.
1
On screen display
• Each time an operation is
performed, a description of that
operation appears
display connected to the unit's
VIDEO MONITOR OUT jack.
Also, the unit's operating status can be
checked during playback by pressing the
remote control unit's ON SCREEN/DISPLAY
button.
Such information as the position of the input
selector and the surround parameter settings
is output in sequence.
2
Using the dimmer function
• Use this to change the
brightness of the display.
The display brightness changes
in four steps (bright, medium,
dim and off) by pressing the
main unit's DIMMER button repeatedly.
BRIGHT
1
(Remote
control unit)
1
Display
IN=V SOURCE
1
on the
2
(Remote
control unit)
(Remote
control unit)
MEDIUM DIM
OFF
1