Denon AVR-1905 Operating Instructions Manual page 16

ENGLISH
Setting the Ext. In SW Level
• Set the playback level of the analog input signal connected to the Ext. In terminal.
1
Select desired setting.
• Select according to the specifications of the player
being used.
Also refer to the player's operating instructions.
• +15dB (default) recommended. (0, +5, 10 and +15
(Remote control unit)
can be selected.)
22 EXT.IN SW+15
2
Press the ENTER or
(Remote control unit)
Setting the On Screen Display (OSD)
• Use this to turn the on-screen display (messages other than the menu screens) on or off.
• Sets the on-screen display's display mode.
Mode 1: Prevents flickering of the on-screen display when there is no video signal.
Mode 2: Flickering is not prevented.
Use this mode if the on-screen display does not appear in the mode 1, as may happen according
to the TV being used.
1
Select "ON" or "OFF".
23 OSD
(Remote control unit)
2
Select the "On Screen
Display" mode.
(Remote control unit)
3
Press the ENTER or
setting.
(Remote control unit)
16
(down) button to switch the On Screen Display setting.
ON
Select the "MODE1" or
24 OSD
"MODE2".
(Remote control unit)
(down) button to switch the Auto Preset Memory
Auto Tuner Presets
• Use this to automatically search for FM broadcasts and store up to 56 stations at preset channels A1 to 8, B1
to 8, C1 to 8, D1 to 8, E1 to 8, F1 to 8 and G1 to 8.
NOTE:
• If an FM station cannot be preset automatically due to poor reception, use the "Manual tuning" operation to
tune in the station, then preset it using the manual "Preset memory" operation.
1
(Remote control unit)
2
(Remote control unit)
After setting up the system
1
(Remote control unit)
This completes the system setup operations. Once the system is set up, there is no need to make the
settings again unless other components or speakers are connected to or the speaker layout is changed.
• On-screen display signals
Signals input to the AVR-1905
MODE1
VIDEO signal input jack
(yellow)
E
1
2 C
3 E
4 C
(C: Signal E: No signal)
Use the CURSOR button to select "Yes".
"Search" flashes on the screen and searching begins.
"Completed" appears once searching is completed.
The display automatically switches to screen.
25 PRESET <YES
Press the ENTER or (down) button if you want to start the settings over from
the beginning.
Press the SYSTEM SETUP button to finish system set up.
On-screen display signal output
Video signal output to
S-video signal input jack VIDEO MONITOR OUT jack
(yellow)
E C
E C
C C
C E
(C: On-screen signals output E: On-screen signals not output)
Video signal output to S-
Video MONITOR OUT jack
C
C
C
C