SATO CL408 Operator And Technical Reference Manual page 20

Label Guide to keep the labels
against the inside of the printer.
9. Close the Label Hold-Down by
pushing downward on the green
tab until it latches closed.
NOTE: If the Label Dispenser option
has been purchased, see Appendix D,
for proper label routing instructions.
10. Adjust the Label Sensor
Assembly to the correct position
by loosening the Sensor Adjust
Cap Screw located on the front side of the Label Hold-Down and moving the
Sensor Adjust Tab to the correct position. After it is correctly positioned,
retighten the Sensor Adjust Cap Screw.
11. If the ribbon is already loaded, close the Print Head Assembly by pushing
downward on the green tab until it latches closed.
12. If the ribbon is not loaded, see the following description for loading instructions.
Media Knob
Printed Labels
Dispenser Routing
SATO CL Series Printers
Section 2. Installation and Configuration
Label Guide
Label Backing
9001035 Rev. E
Label Supply
Guide
Label Roll
Support
Label Roll
Cutter Routing
Page 2-5