Operator Panel; Cl608 And Cl612 - SATO CL408 Operator And Technical Reference Manual

Section 2. Installation and Configuration
the Eye-Mark from a minimum of 0.25 in. (6mm) to a maximum of 2.1 in. (53mm).
See page 2-21 for sensor position range.

OPERATOR PANEL

The CL608/CL612 Operator Panel consists of five LED indicators, two
momentary contact switches, three DIP switches, four adjustment potentiometers and
one LCD Display. All of these are accessible from the front of the printer. They are
used to set the printer operating parameters and to indicate the status of the printer
to the operator. After you power on the printer, familiarize yourself with the keys and
indicators as it will help you understand the configuration process.
PRINT:
OFFSET:
PITCH:
DISPLAY:
POWER:
Page 2-12
POWER LINE LABEL RIBBON
LINE
Reserved DSW2
Potentiometer to adjust print darkness (fine tuning).
Potentiometer to adjust amount of back/forward feed
for dispenser/cutter/tear-off bar position (+/-3.75 mm)
Potentiometer to adjust home position of the label
(+/- 3.75 mm). Affects stop position of label feed, print
position and dispense position.
Potentiometer to adjust the contrast of the LCD.
LED, illuminated when the power is on.
9001035 Rev. E

CL608 and CL612

DISPLAY
PANEL
ERROR
FEED
DISPLAY
PITCH
DSW3 OFFSET
SATO CL Series Printers
LCD
PRINT