Cam-Acl - Dell S4810 Reference Manual

Version 8.3.11.0
Version 8.3.7.0
Usage You must save the configuration and reload the system to implement ASF. When
Information you enter the command, the system sends a message stating that the new mode is
enabled when the system reloads.

cam-acl

Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
S4810
Syntax
Parameters
default
92
Introduced on the Z9000.
Introduced on the S4810.
Use the default CAM profile settings and set the CAM as
follows:
• L3 ACL (ipv4acl): 4
• L2 ACL(l2acl): 6
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 2
• L2 QoS (l2qos): 1
• OpenFlow: 0 (disabled)
• FCoE (fcoeacl): 0 (disabled)
• iSCSI Optimization (iscsioptacl): 0 (disabled)
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller
(256 total entries minus the 14 entries reserved for
internal functionality)
• 8: Creates 498 entries for use by the OpenFlow controller
(512 total entries minus the 14 entries reserved for
internal functionality)
Using the fcoe parameter, enter the number of FP groups to
be allocated for FCoE transit. Enter 1 – 6; maximum six
groups. Each group has 128 entries, creating a total of 768
possible entries for FCoE FP groups. The value given must be
an even number.
Control and Monitoring