Match Interface - Dell S4810 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
ip community-list
Commands
set community

match interface

To match routes whose next hop is on the interface specified, configure a filter.
S4810
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface
274
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures an Community Access list.
— specifies a COMMUNITY attribute.
Enter the following keywords and slot/port or number
information:
• .
• For the loopback interface, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
• For a SONET interface, enter the keyword sonet then the
slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094 (you can use IDs 1 to 4094).
Access Control Lists (ACL)