Set Next-Hop - Dell S4810 Reference Manual

set metric
set tag

set next-hop

To specify an IP address as the next hop, configure a filter.
S4810
Syntax
set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
Parameters
ip-address
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
If you configure the set next-hop command, its configuration takes precedence
Information
over the neighbor next-hop-self command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface's IP address
(either Loopback or physical), the software declares the route unreachable.
Related
match ip next-hop
Commands
Access Control Lists (ACL)
— specifies the metric value assigned to redistributed routes.
— specifies the tag assigned to redistributed routes.
Specify an IP address in dotted decimal format.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop IP address.
293