Enable Optic-Info-Update Interval - Dell S4810 Reference Manual

Usage Users entering EXEC Privilege mode or any other configured privilege level can
Information access configuration commands. To protect against unauthorized access, use the
enable password command to configure a password for the enable command
at a specific privilege level. If no privilege level is specified, the default is privilege
level 15.
Related enable password
Commands
access a privilege level.

enable optic-info-update interval

Enable polling intervals of optical information updates for simple network management protocol (SNMP).
S4810
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-
info-update interval command.
Parameters
interval
seconds
Defaults Disabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.4
Version
8.3.10.0
Usage To enable polling and to configure the polling frequency, use this command.
Information
Control and Monitoring
— configures a password for the enable command and to
Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The
default is 300 seconds (5 minutes).
Introduced on the S6000.
Replacement command for the S4820T. Replaces the
enable xfp-power-updates command.
Replacement command for the Z9000. Replaces the enable
xfp-power-updates command
Replacement command for the S4810 only. Replaces the
enable xfp-power-updates command.
99