Installing The Switchback Unit - Kyocera KM-3035 Service Manual

21. Fit the eject tray to the finisher by hooking the
two claws and secure it using two M4 × 6
binding screws.
22. Open the front panel and insert the stapler unit into the finisher.
When inserting the stapler unit into the finisher, be sure to grasp the upper portion (shaft) of the stapler unit as shown
in the illustration. If the plate in the middle portion (stay transport) is grasped, the unit may be deformed, resulting in
paper jams.
23. Close the front panel.
Front panel

Installing the switchback unit

1. Remove the two support rubbers on the right
of the finisher and loosely fit the two M3 × 8
binding screws in their places.
2. Remove the two screws.
Stapler unit
Figure 1-3-56
Claw
Eject tray
M4 × 6
binding screws
Figure 1-3-55
Shaft
Screw
Figure 1-3-57
2FD/2FF/2FG
Claw
Stay transport
Finisher
Screw
Support rubber
Support rubber
M3 × 8
binding screws
1-3-27