Adjusting Front Position Of The Fixing Unit - Kyocera KM-3035 Service Manual

(7) Adjusting front position of the fixing unit (adjusting lateral squareness)
Follow the procedure below if the drum is not parallel to the fixing unit and theref o re paper is not fed straight to the fixing
section and the trailing edge of image on either the front or rear side becomes longer .
Procedure
Place the original on the contact
glass.
Press the start key and make
a test copy at 100% magnification.
Is the image correct?
Start
No
Yes
End
Original
Tighten the two screws. Refit the front
left cover and close the front cover.
Open the front cover and remove the
front left cover (see page 1-6-36).
Loosen the screw holding each of the
fixing unit and adjusting spacer.
For copy example 1:
Move the adjusting spacer in the direction
of the black arrow (
position of the fixing unit.
For copy example 2:
Move the adjusting spacer in the direction
of the white arrow (
position of the fixing unit.
Screw
Adjusting spacer
Copy
example 1
Figure 1-6-79
) to raise the front
) to lower the front
Fixing unit
Screw
Figure 1-6-80
2FD/2FF/2FG-3.0
Copy
example 2
1-6-41