Kyocera KM-3035 Service Manual page 48

7. Remove 13 screws and take off the rear
cover.
8. Remove 13 screws and take off the shield
cover.
9. Insert the board supports into the three round
holes of the IPC PCB.
Detach the 10-pin connector (four wires) from
YC4 on the main PCB and connect it to J2 on
the IPC PCB.
Figure 1-3-45
Figure 1-3-46
YC15
YC4
10-Pin
connector
Figure 1-3-47
2FD/2FF/2FG
Rear cover
Shield cover
Screws
Main PCB
IPC PCB
J2
1-3-23