Setting Toner Refresh Operation; Performing Drum Refresh Operation; Setting Separation Charger Mode - Kyocera KM-3035 Service Manual

2FD/2FF/2FG-3.0
Maintenance
item No.
U112

Setting toner refresh operation

Description
Sets the drum refresh operation time and the developing bias on time at power on and after copying.
Purpose
To change the drum refresh operation time and the developing bias on time at power on and after cop ying if
image flow level is low.
Method
Press the start key. The screen for executing is displayed.
Setting
1. Select the item to be set. The selected item is displayed in reverse.
2. Change the setting using the cursor up/down keys.
Display
ON TIME(SEC)
BIAS TIME(MSEC) Developing bias on time
3. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No . is displayed.
U113

Performing drum refresh operation

Description
Executes drum refresh operation.
Purpose
To operate when image flow occurs.
Method
1. Press the start key. The screen for executing is displayed.
2. Press the start key. Drum refresh operation starts. (approximately 3 minutes)
3. To stop the operation, press the stop/clear key.
Completion
Press the stop/clear key when the operation stops. The screen for selecting a maintenance item No . is
displayed.
U114

Setting separation charger mode

Description
Specifies Separation Charger (SC) Whole mode to ON/OFF , and the temperature/humidity of which SC Whole
mode is ON.
Purpose
If the paper wrinkles from causes other than low temperature or low humidity (20 °C/ 50 % RH or less), change
the temperature/humidity. If the fixing offset occurs, switch SC Whole mode to OFF .
Method
1. Press the start key. The screen for selecting an item is displa yed.
2. Select the item to be set and press the star t key. The screen for executing each item is displayed.
Display
SELECT SC WHOLE MODE Specifying SC Whole mode to ON/OFF
SELECT TEMP, HUM
SELECT VELLUM MODE
SELECT NORMAL MODE Specifying SC Whole mode to ON/OFF when using plain paper
Setting: SELECT SC WHOLE MODE
1. Select either ON or OFF . The selected item is displa yed in reverse.
Display
ON
OFF
Initial setting: ON
2. Press the start key. The setting is set, and the screen f o r selecting an item is displa yed.
1-4-38
Description
Description
Toner refresh operation time
Description
Specifying the temperature/humidity of which SC Whole mode in ON.
SC Whole mode turns ON when the temperature/humidity becomes
the preset value or less.
Specifying SC Whole mode to ON/OFF when using thin paper
Description
Selecting SC Whole mode
Not selecting SC Whole mode
Setting range Initial setting
50 to 150 (sec) 120
500 to 1000 (msec) 700 (30 cpm)
540 (40/50 cpm)