Kyocera KM-3035 Service Manual page 54

9. Insert the rib of the front cover into the groove
in the top cover of the switchback unit, and
then fit the front cover to the finisher.
10. Secure the front cover by fitting an M4 × 12
TP screw and M4 × 16 TP screw into the
holes where screws were inserted
(see step 8).
11. Fit the two support rubbers removed in step 1
to the switchback unit.
12. If the finisher and the copier do not engage
securely, perform the following finisher height
adjustment.
Adjusting the height of the finisher
1. Remove the two covers from the lower left
part of the finisher by removing one screw
each.
2. Remove the four caps from above the four
casters of the finisher.
Rib
Groove
Front cover
Figure 1-3-61
Figure 1-3-62
Cap
Cap
Cover
Screws
Cover
Figure 1-3-63
2FD/2FF/2FG
Finisher
M4 × 12
TP screw
M4 × 16
TP screw
Support rubbers
Caster
1-3-29