Kyocera KM-3035 Service Manual page 45

2FD/2FF/2FG
4. Insert the upper tabs and lower tabs of the
front and rear lateral size adjusters into the
upper slots and lower slots respectively such
that the size indicators point to the size of
paper to be used. Secure the lateral size
adjusters using the screw for each.
5. Move the front and rear sliders (two at each
point) outward until they make contact with
the lateral size adjusters.
Lower tabs
Lower slots
6. Remove the screw from each of the left and right longitudinal size adjusters.
7. Align the pin holes in the left and right longitudinal size adjusters with the A4 pins or B5 pins according to the size of
paper to be used. Secure the adjusters using the screw for each.
Screw
B5 pins
A4 pins Pin hole
8. Connect the copier power plug to the wall
outlet and turn the copier power switch on.
9. Run maintenance item U208 and set the
paper size for the large paper deck (B5/A4/
Letter).
10. Load paper into the drawer and make a test
copy to check the operation.
1-3-20
Lower tabs
Lower slots
Pin hole
Upper slots
Upper tabs
Upper tab
Upper tab
Upper slots
Figure 1-3-37
Screw
Figure 1-3-38
Size indicator
Upper slots
Upper slots
Longitudinal size adjuster
Screw
Longitudinal size adjuster
A4
LT
B5
B5
LT
A4
Size indicator