Optionally Setting Up The Dip Switch - EverFocus EPN4122 User Manual

3.5.2.4

Optionally Setting Up the DIP Switch

To allow the control device, such as a keyboard, to recognize and then control multiple cameras,
you need to set up the ID address for the cameras using the DIP switch on the Camera Main Body.
You can also set up the Protocol and Baud Rate for the cameras.
Note: Please ensure to turn off the power when setting up the DIP Switch. The new values will
only take effect after restarting the camera.
Camera Main Body
ID Address
The ID address of the camera should be set to correspond properly with the control device, such
as a keyboard. The eight switches on the right correspond with the binary code of the ID address,
allowing up to 256 ID addresses (0 ~ 255) to be set up. Please refer to the sticker on the camera
main body or the following diagram for setting up the ID address. The default ID address is 1.
Sticker on the Camera Main Body
DIP Switch
DIP Switch
10
EPN Series