Lexmark C920 Service Manual page 80

5056-XXX
Message
34 Short Paper
35 Insufficient memory to support
Resource Save feature
37 Insufficient memory to collate
job
37 Insufficient memory for Flash
Memory Defragment operation
37 Insufficient memory, some held
jobs were lost
38 Memory Full
39 Page is too complex to print
2-38
Service Manual
Meaning
The paper used in a print job is
too short in length for the current
print job.
The printer does not have enough
memory to perform the specified
task.
The printer does not have enough
memory to perform the specified
task.
The printer does not have enough
memory to perform the specified
task.
The printer was unable to restore
some or all of the confidential or
held jobs on the hard disk.
Self explanatory.
Self explanatory.
Action
-Select Continue to clear the
message and continue printing.
The printer does not automatically
reprint the page that prompted the
message.
-Check tray length and width guides
to ensure paper is properly fitted in
the tray.
-Make sure the print job is requesting
the correct size of paper.
-Adjust the Paper Size setting for the
size paper you are using.
If MP Feeder Size is set to Universal,
make sure the paper is large enough
for the formatted data.
-Cancel the current job.
-Select Continue to disable
Resource Save and continue
printing.
-To enable Resource Save after you
get this message:
Make sure the link buffers are set to
Auto, then exit the menus to activate
the link buffer changes.
When Ready is displayed, enable
Resource Save.
-Install additional memory.
-Select Continue to print the
portion of the job already stored and
begin collating the rest of the job.
-Cancel the current job.
-Select Continue to stop the
defragment operation and continue
printing.
-Delete fonts, macros, and other
data in printer memory.
-Install additional printer memory.
Select Continue to clear the
message.
-Select Continue to clear the
message and continue printing.
The job may not print correctly.
-Cancel the current job.
-Install additional printer memory.
-Select Continue to clear the
message and continue printing.
The job may not print correctly.
-Cancel the current job.
-Install additional printer memory.