5.2.2 Adjusting the height of the remote (only for
swing–away remote holders)
Requirements:
•
1 x 6 mm Allen key
Loosen the Allen screw A.
1.
2.
Adjust the remote to the desired height.
3.
Re-tighten the Allen screw.
5.2.3 Swivelling the remote to the side
If your mobility device is fitted with a swing-away remote holder,
then the remote can be moved away to the side, for example, to
drive up close to a table.
1528224-Q
Adjusting the mobility device to the user's seating posture
5.3 Adjustment possibilities for the firm seat
unit
5.3.1 Setting the height of the armrests
Requirements:
•
1 x Phillips screwdriver
The armrest on the firm seat is fitted with a screw (1) which is used
as a stop. The armrest height is adjusted using this stop.
1.
Release wing screw (2).
2.
Remove the armrest from the mounting.
29