5.4.2 Adjusting the width of the armrests
WARNING!
Serious injury hazard if one of the armrests
falls out of its bracket because they have been
adjusted to a width which exceeds the permissible
value!
– The width adjustment is fitted with small stickers with
markings and the word "STOP"! The armrests must
never be pulled out further than the point at which
the word "STOP" is completely legible!
– Always tighten the fixing screws properly once
adjustments have been completed!
Requirements:
•
Allen key 8 mm
1.
Loosen screw (1).
2.
Adjust armrest to required position.
3.
Retighten the screw.
4.
Repeat this procedure for the second armrest.
1528224-Q
Adjusting the mobility device to the user's seating posture
5.5 Adjustment possibilities for the Flex 2 seat
unit
5.5.1 Adjusting width of the Flex 2 standard armrest
Requirements:
•
Allen key 8 mm
1.
Loosen screw (1).
2.
Adjust armrest to required position.
3.
Retighten the screw.
4.
Repeat this procedure for the second armrest.
5.5.2 Adjusting the position of the armrest in depth
WARNING!
Serious risk of injury if an armrest falls out of its
bracket because it was pulled too far forward.
– The armrest may be pulled forward out of the bracket
as far as the point where the end of the inserted tube
is flush with the rear of the bracket, but no further.
Requirements:
•
Allen key 3 mm
31