Invacare Spectra XTR User Manual page 83

1. Raise the vehicle and place wooden blocks under it to support it.
2. Remove the screw (1) using the Allen key on one side and the
open-ended spanner on the other side (for countering).
3. Pull the wheel from the fork.
Installation takes place in reverse order. Always ensure
that the wheel is replaced on the same side and in the same
direction as it was removed.
Repairing a flat tire
1. Unscrew valve cap.
2. Depressurize tire by pressing in the pin in the valve.
3. Unscrew the 5 Allen screws (1).
1528224-Q
4. Remove the tire with inner tube from the wheel rim halves.
5. Repair inner tube and re-fit it, or insert new.
If the old inner tube has been repaired and is to be used
again, and became wet during repair, it is easier to replace it
if it is lightly dusted with talcum powder beforehand.
6. Insert the wheel rim halves from outside into the tire.
7. Pump up the tire a little.
8. Insert the Allen screw once again, and screw the wheel rims
together tightly. Avoid crushing the inner tube!
9. Ensure that the tire outer is seated correctly.
10. Pump the tire up to the prescribed pressure.
11. Check that the tire is seated correctly once again.
12. Screw the valve cap back on.
13. Refit the wheel.
Maintenance
83