Adjusting The Backrest (Firm Seat); Adjusting The Backrest (Flex 2 Seat Unit) - Manually Using The Gas Pressure Spring; Adjusting The Height Of The Backrest (Modulite Seat Unit) - Invacare Spectra XTR User Manual

Invacare® Spectra XTR Series
1. Remove the screws (1) on both sides of the backrest that hold
it in position.
2. Set the backrest to the desired angle by selecting a combination
of one of the two holes in the backrest frame, and one of the six
holes in the metal fixation plate.
3. Re-position screws and tighten them.

5.8.4 Adjusting the backrest (firm seat)

The angle of the manually adjustable backrest is continuously
adjustable between +2° and +22°.
Requirements:
•
1 x open-ended spanner 13 mm
•
1 x Phillips screwdriver
The angle of the manually adjustable backrest is adjusted on both
sides by means of an adjustment knob (1) and a limiting screw (2),
which is fitted with a counter nut (3).
1. Loosen the knobs (1) on both sides.
2. Loosen the counter nut (3) of the limiting screw (2), using the
open-ended spanner 13 mm.
3. Adjust the limiting screws (2) evenly on both sides to the desired
backrest angle, using the Phillips screwdriver.
4. Tighten the counter nut (3).
5. Re-tighten the knobs.
40
5.8.5 Adjusting the backrest (Flex 2 seat unit) —
manually using the gas pressure spring
The lever (1) for adjusting the backrest angle is located on the
opposite side from the remote under the armrest. If, for example,
the remote is installed on the right, the lever is located on the left.
1. Pull the lever upwards. Adjust the backrest to the required angle.
2. Release the lever again.
The backrest engages again.
5.8.6 Adjusting the height of the backrest (Modulite
seat unit)
The following section describes the procedures for adjusting the
height of the backrest plate.
The sling back is only available in fixed heights of 48 and 54
cm.
Requirements:
•
1 x 5 mm Allen key
1528224-Q