Connecting The Peripherals; Connecting The Optional External Buzzer - Epson TM-T83II Technical Reference Manual

Connecting the Peripherals

Connect each cable of a peripheral to a port or connector at the rear of the product.
• When connecting USB interface devices, make sure to check the devices or manuals,
CAUTION
• Make sure that the protective cover is securely fit into place while the product is oper-

Connecting the Optional External Buzzer

You can use the optional external buzzer (OT-BZ20) by connecting it to the drawer kick connector.
• The optional external buzzer and the drawer cannot be used together at the same time.
• If you configure the memory switch (customized value) setting to enable the optional external
• Make sure to use the accessory affixing tape (hook and loop fastener) to attach the optional
• Be careful not to spill water, oil, solvent, or any other liquid over the product. Doing so may
Check whether the following items are included.
Optional external buzzer
Installation Position
This product is recommended to be installed on either side of the product.
• Do not install the optional external buzzer at the roll paper exit.
• To prevent liquid from entering inside, it is recommended to install the optional external
36
etc. for current consumption. The total value should be 800 mA or less. Never use
devices that provide no information on current consumption.
ating.
buzzer, the drawer cannot be opened because the pulse is not sent to the drawer kick
connector pin.
external buzzer to the product.
result in malfunction of the product.
buzzer so that the volume adjustment knob is positioned sideways or downward. (For details
of the volume adjustment knob, see
Affixing tape User's Manual
(1 pair, 2 pieces)
"Adjusting the Buzzer Volume" on page 38.)