Part Names; Installing The Printer; Connecting To A Power Source - Epson TM-T70-i User Manual

Part Names

See illustration
Control Panel
FEED button
This button feeds paper.
PAPER OUT LED
On indicates a paper near end or out. Flashing indicates standby.
ERROR LED
This indicates an error.
(Power) LED
This LED is on when the printer is on.

Installing the Printer

You can install this printer only horizontally.
Fix the printer so that it does not move around when you open the printer cover and cut
roll paper. A tape for fixing the printer is available as an option.
As shown in the illustration
printer with a tilt of more than 3° may cause the following problems.
❏
Roll paper near end cannot be detected.
❏
The printer cover will not close after installing roll paper.
❏
Roll paper cannot be taken out.

Connecting to a Power Source

WARNING:
Be sure to use the specified AC Adapter [AC ADAPTER,RA Model: M266A] only.
Note:
It takes approximately 30 seconds after the printer is turned on until it is ready for printing.
Use the power switch on the front of the printer to turn the printer on and off.
Make sure the power switch is turned off, and connect the dedicated AC adapter to the
printer, as shown in illustration
4 TM-T70-i User's Manual
.
B
, install the printer with a maximum tilt of 3°. Installing the
C
.
D