Dedicated Ilo Management Module - HP ProLiant DL160 Gen9 Maintenance And Service Manual

Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Remove the secondary PCIe riser cage
5.
Locate the battery on the system board
6.
Remove the battery.
7.
IMPORTANT:
configuration. After replacing the battery, use BIOS/Platform Configuration (RBSU) in the UEFI
System Utilities
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

Dedicated iLO management module

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
("Access panel" on page 30).
("Secondary PCIe riser
("System board
Replacing the system board battery resets the system ROM to its default
("HP UEFI System Utilities" on page 65) to reconfigure the system.
("Access panel" on page 30).
board" on page 50).
components" on page 76).
Removal and replacement procedures 52