Hp 550-W Power Supply - HP ProLiant DL160 Gen9 Maintenance And Service Manual

Enter the serial number and press the Enter key.
6.
Select Product ID. The following warning appears:
7.
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
Enter the product ID and press the Enter key.
8.
Press the Esc key to close the menu.
9.
Press the Esc key to exit RBSU.
10.
Press the F10 key to confirm exiting RBSU. The server automatically reboots.
11.

HP 550-W Power Supply

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove the server from the rack.
2.
Access the product rear panel.
3.
Release the power cord from the strain relief clip.
4.
Remove all power:
5.
Disconnect the power cord from the power source.
a.
Disconnect the power cord from the server.
b.
Remove the server from the rack (on page 29).
6.
Remove the access panel
7.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Remove the server from the
("Access panel" on page 30).
rack" on page 29)
Removal and replacement procedures 62