Hot-Swap Fan - HP ProLiant DL160 Gen9 Maintenance And Service Manual

Remove the fan blank.
7.
CAUTION:
all bays are populated with either a component or a blank.
To replace the component, reverse the removal procedure.

Hot-swap fan

WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause ESD.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
To prevent improper cooling and thermal damage, do not operate the server unless
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
("Access panel" on page 30).
Removal and replacement procedures 40