Remove The Server From The Rack; Non-Hot-Plug Drive Carrier - HP ProLiant DL160 Gen9 Maintenance And Service Manual

In a server that uses thumbscrew rack ears, loosen the captive thumbscrews that secure the server
o
faceplate to the front of the enclosure, and then slide the server out of the enclosure.
In a server that uses quick-release latch rack ears:
o
Open the latches on both sides of the server.
i.
If necessary, use a T-25 Torx screwdriver to loosen the shipping screws.
ii.
Slide the server out of the enclosure.
iii.
After performing the installation or maintenance procedure, slide the server back into the enclosure,
5.
and then press the server firmly into the enclosure to secure it in place.
Connect the peripheral cables.
6.
Connect each power cord to the server.
7.
Connect each power cord to the power source.
8.

Remove the server from the rack

WARNING:
equipment:
Observe local occupational health and safety requirements and guidelines for manual
•
material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. HP recommends that a minimum of two people are required
for all rack server installations. A third person may be required to help align the server if the
server is installed higher than chest level.
Use caution when installing the server in or removing the server from the rack; it is unstable
•
when not fastened to the rails.
To remove the server from an HP, Compaq-branded, Telco, or a third-party enclosure:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Disconnect all peripheral cables from the server.
3.
Remove the server from the rack.
4.
For instructions on how to extend or remove the server from the rack, see the documentation that ships
with the rack rail system.
Place the server on a sturdy, level surface.
5.

Non-hot-plug drive carrier

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
This server is very heavy. To reduce the risk of personal injury or damage to the
To prevent improper cooling and thermal damage, do not operate the server unless
Removal and replacement procedures 29