Navigating The Zyair Web Configurator; Figure 9 Example Xmodem Upload - ZyXEL Communications ZyAIR G-5100 User Manual

Obtain the default configuration file, unzip it and save it in a folder. Use a console cable to
connect a computer with terminal emulation software to the ZyAIR's console port. Turn the
ZyAIR off and then on to begin a session. When you turn on the ZyAIR again, you will see the
initial screen. When you see the message "Press any key to enter Debug Mode within 3
seconds" press a key to enter debug mode.
To upload the configuration file, do the following:
1 Type "atlc" after the Enter Debug Mode message.
2 Wait for the Starting XMODEM upload message before activating XMODEM upload on
your terminal.
3 This is an example Xmodem configuration upload using HyperTerminal. Click Transfer,
then Send File to display the following screen.

Figure 9 Example Xmodem Upload

4 After a successful configuration file upload, type "atgo" to restart the ZyAIR.
The ZyAIR is now reinitialized with a default configuration file including the default
password of "1234" and IP address of 192.168.1.2.

2.4 Navigating the ZyAIR Web Configurator

The following summarizes how to navigate the web configurator from the MAIN MENU
screen.
Note: Follow the instructions you see in the MAIN MENU screen or click the
icon (located in the top right corner of most screens) to view online help.
The icon does not appear in the MAIN MENU screen.
Chapter 2 Introducing the Web Configurator
ZyAIR G-5100 User's Guide
Type the configuration
file's location, or
click Browse to
search for it.
Choose the Xmodem
protocol.
Then click Send.
39