template-refresh
2.3 IPFIX Collector Configuration
The following command is used to configure an IPFIX collector.
CLI:
ERS 8300
o
ERS-8300(config)# ip ipfix collector <ipaddr> ?
ERS 8600
o
ERS-8600(config)# ip ipfix collector <slot#> <ipaddr> ?
dest-port
enable
exporter-ip
protocol
protocol-version
PPCLI:
ERS 8300:
o
ERS-8300# config ip ipfix collector ?
ERS 8600
o
ERS-8600# config ip ipfix slot <slot #> collector ?
Sub-Context:
Current Context:
add
ip
<value>]
info
remove
where:
Parameter
slot#
<ipaddr>
protocol
dest-port
Specifies the interval, in seconds, between refreshes and the interval,
in number of packets, between refreshes. Range for interval is 300 to
3600 seconds. Range for packets is 10,000 to 100,000.
Destination port
State of the collector
Ip address of the exported traffic
Type of the protocol
Ipfix protocol version
<ipaddr>
[protocol
<value>]
[protocol-version
<ipaddr>
Description
Indicates the slot for the collector.
Note: If you do not specify a slot, the command applies to all
slots.
Specifies the IP address of the collector you are adding.
Specifies the protocol to use. UDP is the default.
Specifies the destination port.
Avaya Inc. – External Distribution
[dest-port
<value>]
<value>]
[enable
<value>]
avaya.com
[exporter-
10