Simulating Trail Or Route Navigation; Initialize Gps - Lowrance GlobalMap 5200C GPS Operation Instructions Manual

A message and tone appear periodically, warning you that the simula-
tor is on. To turn the simulator off, repeat the above steps or turn the
unit off.
While in simulator mode, you can press
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation.
To turn steering and speed boxes back on again, return to the GPS
Simulator menu, select the
Press |
EXIT EXIT

Simulating Trail or Route Navigation

In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
TION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
2. Set to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
press ↑ to increase speed to the desired setting.
4. Press to turn off the steering and speed boxes. The unit will now
EXIT
automatically "steer" along the trail or route. When you arrive at your
"destination," cancel navigation as you normally do.
Tip:
You can pick any spot on the map to begin your simulation session
by using the Initialize GPS command. This makes your unit think
it's located at the position you select.

Initialize GPS

This command is used when you are practicing in simulator mode. (See
the entry in this section for GPS Simulator.) In simulator mode, this
command makes the unit operate as if it is sitting someplace other
than its actual location. So, you and your unit could be located in Kan-
sas City, but easily practice navigating in the ocean off Islamorada,
Florida.
1. Press |
MENU
www.Busse-Yachtshop.de
S
TEER WITH
| to return to the previous page.
EXIT
S
TEER WITH
to clear the alarm. When navigation starts,
EXIT
|↓ to
MENU GPS S
to clear the steering and
EXIT
command, press
A
RROWS
command and press
A
RROWS
| | .
ENT ENT
ETUP
79
email: info@busse-yachtshop.de
, then
ENT
S P
TARTING OSI-
,
ENT