Lowrance GlobalMap 5200C GPS Operation Instructions Manual page 145

Highlight
11. C
pear: Full Level Calibration Completed. Press
peatedly to get back to the main display.
Num Pts menu with 5-point calibration selected (left). Half level se-
lected on Fluid Level menu (center). Calibration Done window (right).
5-Point Calibration
5-point calibration is best suited tanks that vary greatly in shape from
top to bottom. You can begin calibration at any point in the 5-point
calibration process. We recommend starting calibration with an empty
tank. In a five-point calibration you will set five points: Empty Level, 1
Qtr Level, Half Level, 3 Qtr Level and Full Level. In a 5-point calibra-
tion, you will have four calibration points left after calibrating your
tank's Empty Level.
To figure out how much fuel you should add for the remaining steps of
the calibration process, divide the total capacity of you tank by four. So,
if you have a 40-gallon tank, each quarter tank will equate to 10 gal-
lons.
1. Press
MENU| MENU
2. Highlight
B
US
ration menu. A list of network devices will be at the top of the page. 3.
Select the desired EP-15 Fluid Level and press
4. Press ↓ to select
menu will appear.
5. Highlight
N
UM
Make sure your tank is empty, then highlight
6.
. Select
ENT E
MPTY LEVEL
Select
7. C
ALIBRATE
Empty Level Calibration Completed. Press
Add 1 quarter tank of fuel, highlight
8.
1 Q L and press ENT .
TR EVEL
www.Busse-Yachtshop.de
and press
ALIBRATE
, use ↓ ↑ to select
and press
S
ETUP
C
ALIBRATE
, press
P ENT
TS
and press
and press
ENT
. The following message will ap-
ENT
NMEA 2000
, which will open the Bus Configu-
ENT
and press
ENT
and select . Press
5
ENT .
. The following message will appear:
ENT
F L
LUID EVEL
139
email: info@busse-yachtshop.de
, then press
ENT
and press
ENT
.
ENT
. The Device Calibration
.
ENT
F L
LUID EVEL
.
and press
ENT
re-
EXIT
.
and press
. Select