Table of Contents
Advertisement
tude/longitude (Starting Position) or from a stored waypoint, map place
or POI location (Select Starting Waypoint). You can steer your position
on the map by using the arrow keys (
track and speed in the boxes provided on simulator screen.
To get to the GPS Simulator:
1. Press
MENU
2. Press ↓ to
Make the desired settings, then turn the simulator on by highlighting the
S
O
IMULATOR
N
message appears periodically, reminding you that the simulator is on. To
turn the simulator off, repeat the above steps or turn the unit off.
While in simulator mode, you can press
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
S
TEER WITH
|
|
EXIT
EXIT
EXIT
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
SITION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
offered by www.Busse-Yachtshop.de
|
|↓ to
MENU
GPS S
|
GPS S
IMULATOR
The GPS Simulator Menu.
box and pressing
A
RROWS
to return to the previous page.
S
TEER W
|
.
ENT
ETUP
.
ENT
key. Press
ENT
EXIT
command, and press
60
email: info@busse-yachtshop.de Tel: +49 (0)4347 908234
) or by setting the
/ A
RROWS
to erase this menu. A
EXIT
to clear the steering and
, then press
ENT
S
P
TARTING
O-
Advertisement
Table of Contents
