Simulating Trail Or Route Navigation - Lowrance iFINDER H2O C Operation Instructions Manual

GPS Setup Menu (left) with GPS Simulator Menu (right).
Choose the desired settings, then turn on the simulator by highlighting
GPS S
IMULATOR
(uncheck) the simulator. Press
pears periodically, reminding you the simulator is on. To turn off the
simulator, repeat the steps above or turn off the unit.
While in simulator mode, you can press
speed boxes from the screen. This will allow you to use the map cursor
during a simulation. To turn on the steering and speed boxes again,
return to the GPS Simulator menu, select
.
ENT

Simulating Trail or Route Navigation

In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
SITION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
2. Set to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
press ↑ (since you're using the Simulator's
to increase speed to the desired setting.
4. Press to turn off the steering and speed boxes. The unit will now
EXIT
automatically steer along the trail or route. When you arrive at your
destination, cancel navigation as you normally do.
and pressing
O
N
to clear the alarm.) When navigation starts,
EXIT
, which will turn on (check) or turn off
ENT
to close this menu. A message ap-
EXIT
EXIT
S A
TEER WITH RROWS
74
to remove the steering and
S A
TEER WITH RROWS
command and press
S A
TEER WITH RROWS
and press
S P
TARTING O-
,
ENT
command)