Gps Simulator; Simulating Trail Or Route Navigation - Lowrance iFINDER GO Advanced User's Manual

GPS Simulator

The GPS simulator lets you use the unit as if you were outdoors navi-
gating somewhere. You can set the starting location in lati-
tude/longitude (Starting Position) or from a stored waypoint or Map
Place (Select Starting Waypoint). You can steer your position on the
map by using the arrow keys (
and speed in the boxes provided on simulator screen.
To get to the GPS Simulator:
1. Press
MENU
2. Press ↓ to
GPS S
Make the desired settings, then turn the simulator on by highlighting
the
S
IMULATOR
menu. A message appears periodically, reminding you that the simula-
tor is on. To turn the simulator off, repeat the above steps or turn the
unit off.
While in simulator mode, you can press
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
S
TEER WITH
| |
EXIT EXIT EXIT

Simulating Trail or Route Navigation

In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approximate
SITION
(shown in compass degrees) that will point you toward the start
T
RACK
of the trail/route.
| |↓ to
MENU GPS S
|
IMULATOR
GPS Simulator Menu.
box and pressing
O
N
A
RROWS
to return to the previous page.
S / A
TEER W RROWS
|
ENT
ETUP
.
ENT
key. Press
ENT
EXIT
command, and press
61
) or by setting the track
.
EXIT
to clear the steering and
ENT
to erase this
, then press
S P
TARTING O-