Suzuki RM-Z250 Owner's Manual page 148

4-68 DISASSEMBLY AND ASSEMBLY
• Tighten the caliper mounting bolts 2 to the specified torque.
 Front brake caliper mounting bolt:
• Tighten the brake pad mounting pin 3 to the specified torque.
 Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lbf-ft)
• Set the brake hose end between the hose stopper A, then
tighten the brake hose union bolt 4 to the specified torque.
NOTE:
Replace the seal washers with new ones.
 Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lbf-ft)
• Install the pad mounting pin cap.
• Refill brake fluid and bleed air from the brake system.
(4-61)
REAR CALIPER REMOVAL AND DISASSEMBLY
• Remove the disk cover 2 by removing their bolts 1.
• Remove the caliper protector 4 by removing their bolts 3.
• Place a rag under the brake hose union bolt 5 to catch spilled
brake fluid.
• Disconnect the brake hose 6 by removing the union bolt 5.
• Remove the rear wheel. (4-57)
• Remove the caliper.
26 N·m (2.6 kgf-m, 19.0 lbf-ft)