Suzuki RM-Z250 Owner's Manual page 111

CYLINDER HEAD COVER INSTALLATION
Install the cylinder head cover in the reverse order of removal.
Pay attention to the following points:
• Install the new cylinder head cover gasket 1 to the cylinder
head cover 2.
NOTE:
* Check to be sure that the cam chain No.2 guide 3 is securely
installed on the cylinder head cover 2.
* Replace the cylinder head cover gasket 1 with a new one.
• Apply bond to the end caps of the cylinder head cover gasket
as shown.
 99000-31140: SUZUKI BOND "1207B" or equivalent
• Install the cylinder head cover No.2 gasket 4.
NOTE:
Replace the cylinder head cover No.2 gasket 4 with a new one.
NOTE:
Fit the protrusion A of the cylinder head cover No.2 gasket 4 to
the stopper groove B.
• Place the cylinder head cover on the cylinder head.
• Apply engine oil to both sides of gaskets 5.
NOTE:
Replace the gaskets 5 with new ones.
• Tighten the cylinder head cover bolts 6 to the specified
torque.
 Cylinder head cover bolt: 14 N·m (1.4 kgf-m, 10.0 lbf-ft)
• Install the spark plug and ignition coil/plug cap. (2-8)
• Install the radiator covers and fuel tank.
• Install the seat.
INSPECTION AFTER INSTALLATION
• Engine oil level and oil leakage (2-13)
• Engine coolant level and coolant leakage (2-19, -20)
• Fuel leakage
• Exhaust gas leakage
• Throttle cable play (2-22)
• Clutch cable play (2-21)
• Wiring harness, cable and hose routing (5-10 to -13)
DISASSEMBLY AND ASSEMBLY 4-31