3Com 4500 PWR 26-Port Configuration Manual page 778

Displaying the Sys
Display the current date and time of the system
Display the version of the system
Display the information about use
switch
Deb ugging the System
Enab ling/Disabling System Debugging
The device provides various debugging functions. For the majority of protocols and featu
the system provides corresponding debugging information to help users diagnose errors.
The following two switches control the display of debugging information:
Protocol debugging switch, which controls protocol-specific debugging information
Screen output switch, which controls whether to display the debugging information on a certain
screen.
Figure 61-1 illustrates the relationship between the protocol debugging switch and the screen output
switch. Assume that the device can output debugging information to module 1,
are turned on can debugging information be output on a terminal.
Figure 61-1 The relationship between the protocol and screen debugging switch
Displaying debugging information on the terminal is the most commonly used way to output debugging
in formation. You can also output debugging information to other directions. For details, refer to
Information Center Operation.
tem St atus
To do...
rs logging onto the
61-2
Use the command...
display clock
display version
display users [ all ]
2 and 3. Only when both
Remarks
Available in
any view
res supported,