Table of Contents
Advertisement
2.4.3.1 Connection a Video Camera, AIS Receiver, VHF and Autopilot
VIDEO
Camera
CPF390i
Transducer
The Input and Output baud rate for each port is set using the Advanced
Setup>In/Out Connections menu. For example if Port1 is set for AIS 38400, the
Input and Output both operate at 38400 baud.
2.4.3.2 AIS Setup
The CPF390i has to be set up to be able to receive NMEA information from the AIS receiver.
The GPS Chart Plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5. Select the
used port and transmission speed by following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT2 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
2.5
BATTERY CONNECTIONS
1. The GPS Chart Plotters are supplied with a fuse and holder. This fuse should be
installed into the Black wire to protect the NMEA Output/Input circuits from possible
damaged.
2. Connect the Red and Black wires from the GPS Chart Plotter to a 12VDC source as
directly as possible.
2.6
NMEA CONNECTIONS
The GPS Chart Plotter can be connected to external devices with NMEA and display
information, examples:
· DSC VHF Radio
· Depth Sounder, Speed Log, Wind Instrument, Autopilot etc.
· Radar (USA O
CP390i and CPF390i
)
NLY
Optional WAAS GPS
antenna
Red
Black
Blue
Brown
Gray
Yellow
NOTE
Switch
2A
Battery
Fuse
10-35Vdc
VHF
Port 1 Input
Port 1 Output
Port 2 Input
Port 3 Output
-
+
AIS
PILOT
Page 21
Advertisement
Table of Contents
