Transducer Setup; Keel Offset; Calibrate Water Speed; Calibrate Water Temp - Standard Horizon CPF390i Owner's Manual

17.13 TRANSDUCER SETUP

This menu allows you to calibrate the speed through the water, water temperature and the
keel/prop offset of the transducer.
17.13.0

Keel Offset

The keel offset can be set to cause the Fish Finder to display an offset depth below the keel
or the actual water depth from the surface. To setup to show the depth below the keel, enter
a negative depth value or a positive depth to show offset from the transducers face to the
water surface.
17.13.1

Calibrate Water Speed

Used to calibrate the Water Speed readings from the transducer. Adjustment can be made
from -10% to +10%.
17.13.2

Calibrate Water Temp

Used to calibration on the Water Temperature sensor in the transducer.
17.13.3

Set Defaults

Restores the factory settings.

17.14 ALARMS

The Alarms Menu allows you to define alarm settings for Shallow Alarm, Depth Alarm and
Temperature Upper/Lower/Rate.
Page 130
Figure 17.13 - Transducer Setup Menu
CP390i and CPF390i