Table of Contents
Advertisement
4. REPLACEMENT PROCEDURE
74
6. Remove the IR connector on the
right side of the main body.
7. Open the right door and remove the
rear right cover. (3 screws)
8. Remove the shield cover. (15
screws)
9. Open the tab of the memory slot of
the MFP control board (PWB-MFPC)
and remove the memory.
NOTE
• When reinstalling the memory, take
note of the direction in which the
DIMM is inserted. And be sure to
insert it securely until the tabs on
both sides of the slot are set fully
into the notches on the DIMM side.
• Reinstall the above parts following
the removal steps in reverse.
Tab
Service Manual
Field Service Ver. 7.0 Jan. 2009
Y104784-2
Advertisement
Table of Contents
