Baxi Genesis 80 Installation And Servicing Instructions page 33

Genesis
CHANGING COMPONENTS – Page 33
Supplied By www.heating spares.co Tel. 0161 620 6677
Spark Generator
Disconnect generator lead at connection on power board
(K).
Lift power board partially from locating pegs to allow the
release of the generator from its locating pins.
Disconnect terminals to L, N & Earth.
Replace spark generator or wiring as necessary.
Reassemble in reverse order.
POWER BOARD
Disconnect spark generator lead at connection (K) on power
board.
Unplug the link plug connecting the two P.C.B.s at (B).
Lift power board from locating pegs.
Reassemble in reverse order.
CONTROL BOARD
Unplug the link plug connecting the two P.C.B.s at (B).
Remove the three control knobs by pulling off from the
spindles.
Lift the control board from the locating pegs.
Replace the new P.C.B. in reverse order of dismantling
ensuring the correct location on the pegs.
Ensure the slide switch is in the left hand position.
NOTE: One of the control knobs has a longer locating
spindle, this is used on the 'On/Off' selector switch.
Baxi Heating Ltd.
33