Table of Contents
Advertisement
Genesis
Making The Electrical Connections – page 22
44 - 45
Supplied By www.heating spares.co Tel. 0161 620 6677
The electrical connections are on the right hand side of the
unit.
Undo the screws securing the small cover and remove the
cover.
Undo the screw securing the right hand cable clamp and
hinge up.
If fitting an integral timer kit please refer to kit
instructions at this stage, paying particular attention to
voltage requirements.
Route the incoming electrical cable/s over the top edge of
the support bracket. This will prevent damage to the
cables.
Lay the cable/s through the cable clamp to gauge the length
of cable required when the plug is connected.
Connect the (L) and (N) wires to the multipin plug, and the
earth wire to the grounding strip earth point.
The incoming cable/s can be routed through the cable clip at
the right hand side of the support bracket.
Check the electrical installation for earth continuity,
short-circuits, resistance to earth-correct polarity and
fuse failure.
CONNECTING AN EXTERNAL DEVICE
If a Baxi Genesis Controller (programmable thermostat)
is fitted refer to the instructions supplied with it.
To connect an external timer or room thermostat, remove the
link wire between terminals 1 & 2.
This connection delivers a low voltage switching signal to the
external controls, therefore only devices having voltage-free
switch contacts can be connected.
IMPORTANT: DO NOT CONNECT MAINS 230V TO
TERMINALS 1,2 OR 3- DAMAGE TO THE P.C.B. WILL
OCCUR.
Baxi Heating Ltd.
Advertisement
Table of Contents
