FUNAI T3B-N8182DB Owner's Manual page 95

E3B41BD_EN_+nasi.book Page 95 Wednesday, February 7, 2007 6:49 PM
T
Symptom
The power does not turn on.
The unit turns on automatically without any
operation.
The power turns off automatically.
Symptom
The unit does not function.
No picture, sound or menu appears on the
screen.
Clock Setting and Channel Setting cannot be
performed.
The unit does not operate properly.
Symptom
TV channels cannot be changed.
Only specific channels do not appear.
The external input channels (such as AV1,
AV2 or AV3) cannot be skipped.
Symptom
The image from the external device
cannot be displayed or recorded.
Recording is impossible.
Timer Recording cannot be performed.
Recording is impossible.
Recording is impossible.
Solution
• Check that the AC power cord is connected securely.
• Batteries of the remote control are weak.
• The unit turns on automatically 2 minutes before the Timer Recording.
• The power turns off automatically when abnormality is detected on the
STANDBY-ON] or [OPEN / CLOSE O] on the unit to
disc. Press [
open the disc tray, and before it is opened completely, press the button
again. Then take out the disc.
• The power turns off automatically when an OTR is completed.
Solution
• " " or error message appears if the operation is prohibited.
• Batteries of the remote control are weak or exhausted.
• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Check if a correct external input channel is selected on your TV. (See
page 17.)
• Check if you have completed the Channel Setting. (See pages 18 to 21.)
• If a recording is in progress, these operations cannot be performed.
• Moisture has condensed inside the unit. Remove the disc and leave the
unit turned on for about two hours until the moisture evaporates. (See
page 3.)
Solution
• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Try Channel Setting by following the steps on pages 18 to 21.
• The channels may be set to be skipped. (See page 19.)
• This unit does not skip the external input channels. This is not a
malfunction.
Solution
• Try pressing [INPUT SELECT] repeatedly.
• Turn on all connected devices.
• Check if the connections are made securely and correctly.
• This unit cannot record programmes that contain copy protection signal.
This is not a malfunction.
• The space of the recording media may be used up. Try deleting
unnecessary titles from the Original, or exchange it with the recordable
media.
• The maximum number of titles or chapters has exceeded.
Delete the unnecessary titles to make enough space or insert a new
recordable media.
• Check if the connections are made securely and correctly.
• The internal clock of the unit may have been stopped due to a power
failure that lasted for more than 30 seconds. Reset the clock. (See pages
21 to 22.)
• Copy-once programmes can only be recorded on a CPRM compatible
VR mode DVD-RW.
• Check if the disc is protected or finalised. Undo the protection or the
finalisation.
• DVD-RW once formatted with other DVD recorders cannot be recorded
on this unit. This is not a malfunction.
• Video mode DVDs recorded by other DVD recorders cannot be used on
this unit unless finalised.
• Check if the connections are made securely and correctly.
• Check if a videotape is inserted.
• Check if a videotape has a record tab intact.
95
EN