Digital Audio Setting - FUNAI T3B-N8182DB Owner's Manual

E3B41BD_EN_+nasi.book Page 83 Wednesday, February 7, 2007 6:49 PM

Digital Audio Setting

1
Press [SETUP] in stop mode.
Setup Menu will appear.
2
Select "Digital Audio Setting" using
[Cursor
/
Setup Menu
Disc Management
Editing Editing
Dubbing Dubbing
Timer Programme Timer Programme
Title List Title List
Initial Setting Initial Setting
Digital Audio Setting
Playback Playback
Recording Recording
Display Display
3
Select a desired item using
[Cursor
/
Digital Audio Setting
Down Sampling
Dolby Digital Dolby Digital
MPEG MPEG
DTS DTS
Dynamic Range Control Dynamic Range Control
4
Refer to 1. to 5. on pages 83 to 84
and set the selected item.
5
When you finish with the setting,
press [SETUP] to exit.
1. Down Sampling (Default: 48kHz)
Set the Down Sampling.
(Follow steps 1 to 2 above.)
Select "Down Sampling" using
[Cursor
/
Option window will appear.
Select the desired setting using
[Cursor
/
The selected setting will be checked and
activated.
48kHz: If your amplifier / decoder is NOT compatible
with 96 kHz PCM, select "48kHz". Sound
recorded at 96 kHz is down sampled to
48 kHz.
96kHz: If your amplifier / decoder is compatible with
96 kHz PCM, select "96kHz". Sound is
sampled at 96 kHz.
], then press [ENTER].
01/01/07(Mon) 19:34
], then press [ENTER].
01/01/07(Mon) 19:34
], then press [ENTER].
], then press [ENTER].
48kHz
96kHz 96kHz
Note
When playing back disc with copyright protection:
• Even if you select "96kHz", the sound will be down
sampled at 48 kHz.
2. Dolby Digital (Default: Bit Stream)
Set the Dolby Digital.
(Follow steps 1 to 2 on the left.)
Select "Dolby Digital" using
[Cursor ] then press [ENTER].
/
Option window will appear.
Select the desired setting using
[Cursor ], then press [ENTER].
/
Bit Stream
PCM PCM
The selected setting will be checked and
activated.
Bit Stream: Outputs Dolby Digital signals.
If your amplifier / decoder is compatible
with Dolby Digital, set to "Bit Stream".
PCM: Converts the Dolby Digital into PCM
(2 channel).
If your amplifier / decoder is NOT
compatible with Dolby Digital, set to
"PCM".
Hint
When playing back the HDD or a DVD-RW disc
recorded in VR mode:
• If the audio source on a disc is in Dolby Digital
format, set "Dolby Digital" to "PCM" so that you can
switch to main audio (L), sub audio (R), or a
combination of both (L / R) using your amplifier /
decoder.
3. MPEG (Default: PCM)
Set the MPEG.
(Follow steps 1 to 2 on the left.)
Select "MPEG" using [Cursor
then press [ENTER].
Option window will appear.
Select the desired setting using
[Cursor ], then press [ENTER].
/
Bit Stream
PCM
The selected setting will be checked and
activated.
Bit Stream: Outputs MPEG Audio signals.
If your amplifier / decoder is compatible
with MPEG, set to "Bit Stream".
PCM: Converts MPEG into PCM.
If your amplifier / decoder is NOT
compatible with MPEG, set to "PCM".
83
]
/
EN