The MLD Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
enable mld_snooping
disable mld_snooping
config mld_snooping
config mld_snooping
mrouter_port
config mld_snooping
mrouter_port_forbidden
show mld_snooping
show mld_snooping
forwarding
show mld_snooping
group
show mld_snooping
mrouter_port
Each command is listed in detail, as follows:
enable mld_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the MLD snooping:
Parameter
[<vlan_name 32> | all] {host_timeout <sec 60-16711450> | router_timeout <sec
1–16711450> | done_timer <sec 0-16711450> | state [enable | disable]}
<vlan_name 32> [add | delete] <portlist>
<vlan_name 32> [add | delete] <portlist>
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32> | static | dynamic| forbidden }
To enable MLD snooping on the Switch.
enable mld snooping
The enable mld snooping command enables MLD snooping on the
Switch.
None
Only administrator or operator–level users can issue this command
DGS3100# enable mld_snooping
Success.
DGS3100#
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
MLD SNOOPING COMMANDS
18
120