Operation Procedure - Daikin Super Multi Plus E-Series FTXG25EV1BW Service Manual

SiBE18-821_C
The setting temperature range of the remote
controller is 16°C to 32°C.
VRV System
See the operation manual provided with the
air conditioner.

5. OPERATION PROCEDURE

Refer to figure 1 on page [1]
• Operating procedure varies with heat
pump type and cooling only type.
Contact your Daikin dealer to confirm
your system type.
• To protect the unit, turn on the main
power switch 6 hours before operation.
• If the main power supply is turned off
during operation, operation will restart
automatically after the power turns
back on again.
COOLING, HEATING, AUTOMATIC,
FAN, AND PROGRAM DRY
OPERATION
Operate in the following order.
• AUTOMATIC OPERATION can be
selected only by Heat pump split system.
• For cooling only type, COOLING , and
FAN and DRY operation are able to
select.
〈〈FOR SYSTEMS WITHOUT COOL/
HEAT CHANGEOVER REMOTE
CONTROL SWITCH〉〉
Refer to figure 1-1, 2 on page [1]
1
Press OPERATION MODE SELECTOR
button several times and select the
OPERATION MODE of your choice as
follows.
COOLING OPERATION...................
HEATING OPERATION....................
7
Operation Manual
OPERATION MODE
SELECTOR
SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series
AUTOMATIC OPERATION................
• In this operation mode, COOL/HEAT
changeover is automatically conducted.
FAN OPERATION.............................
DRY OPERATION .............................
• The function of this program is to
decrease the humidity in your room with
the minimum temperature decrease.
• Micro computer automatically
determines TEMPERATURE and
FAN SPEED.
• This system does not go into operation
if the room temperature is below 16°C.
ON/OFF
2
Press ON/OFF button
OPERATION lamp lights up or goes off and
the system starts or stops OPERATION.
NOTE
• Do not turn OFF power immediately
after the unit stops. Then, wait no less
than 5 minutes.
Water is leaking or there is something
else wrong with the unit.
〈〈FOR SYSTEMS WITH COOL/HEAT
CHANGEOVER REMOTE CONTROL
SWITCH〉〉
Refer to figure 1-1,3 on page [1]
OPERATION MODE
1
SELECTOR
(1) Select OPERATION MODE with the
COOL/HEAT CHANGEOVER REMOTE
CONTROL SWITCH as follows.
COOLING OPERATION ............
HEATING OPERATION.............
English
315