Daikin Super Multi Plus E-Series FTXG25EV1BW Service Manual page 277

SiBE18-821_C
3 I WANT TO DELETE ONE OR MORE
PROGRAMMED ACTIONS
Make sure you are not in program mode (
blinking); if required, press
mode.
Browse to the programmed actions using the
button, select the day you want to edit.
Press the button for 5 seconds; program mode is
enabled, the icon and selected action are blinking.
Select the "last action" you want to keep using the
button. All higher actions will be deleted.
Confirm the deletion by pressing the
seconds,
OR
confirm the deletion for the current and the next day
too by pressing the
simultaneously for 5 seconds.
NOTE In the case above, if for example the last
action was 3, the programmed actions 4
and 5 will also be deleted (if they were
present).
4 I WANT TO DELETE ALL PROGRAMMED
ACTIONS AT ONCE
Quit programming or browsing.
Press the and
seconds; the
confirm deletion.
7. Maintenance
The remote controller does not need maintenance.
Remove dirt with a soft damp cloth.
NOTE Only use clear tapid water to moisten the
cloth.
Operation manual
13
Operation Manual
to quit program
button for 5
and buttons
buttons simultaneously for 5
icon will invert and disappear to
SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series
8. Troubleshooting
The guidelines below might help to solve your
not
problem. If you cannot remedy the problem, consult
your installer.
No readings on the remote controller (display
blank)
Check if the mains power is still applied to your
installation.
Only is displayed
This indicates that the installation has just been
powered, please wait until
The schedule timer does work but the
programmed actions are executed at the wrong
time (e.g. 1 hour too late or too early)
Check if the clock and the day of the week are set
correctly, correct if necessary (refer to "CLOCK
SETTING FUNCTION" on page 4).
I cannot enable the schedule timer (the
blinks for 2 seconds and disappears)
The schedule timer has not been programmed yet.
First program the
"Programming the schedule timer" on page 10).
I cannot enable the schedule timer (the
icon is displayed)
The schedule timer can not be enabled when a
centralised control is connected.
Limit operation cannot be selected
Limit operation is not available for cooling only
installations.
disappears.
icon
schedule timer (refer to
BRC1D528
Remote controller
4PW23717-1
4PW23717-1
265